Description
Complete CB Radio Kit: Luiton LT-198 + PNI Trucker 9000 PL LED
Small radio. Full 4W CB power. Trucker-class antenna. The Luiton LT-198 + PNI Trucker 9000 PL LED kit combines a remarkably compact CB transceiver with a substantial, premium-style vehicle antenna and a strong 145 mm magnetic mounting base.
Designed for cars, vans, trucks and campers, this complete 27 MHz AM/FM CB radio kit provides the main components needed for a vehicle CB installation: radio, microphone, radio mounting hardware, antenna, magnetic base and coaxial cable.
The distinctive PNI Trucker 9000 antenna features a stainless-steel whip and transparent LED-equipped coil housing, giving the installation the classic appearance of a serious CB radio setup while the miniature Luiton radio takes up very little cabin space.
Luiton LT-198: compact body, full 4W CB performance
The Luiton LT-198 is a compact mobile CB radio measuring approximately 105 × 110 × 25 mm. Its small size makes it suitable for discreet installation in cars, trucks and other vehicles without sacrificing the essential features of a traditional CB transceiver.
- 4W RF output power for standard CB communication.
- AM/FM modulation for compatible CB channels.
- 12/24V compatibility in the updated radio version.
- Multi-country channel configurations for European CB operation.
- Automatic squelch (ASQ) and adjustable manual squelch (SQ).
- RF Gain adjustment for control of receiver sensitivity.
- Up/Down channel controls on the microphone.
- Quick access to channels 9 and 19 and key-lock function.
- LED channel display with RX/TX signal indicator.
- Built-in speaker and external speaker socket.
- Aluminium housing for effective heat dissipation.
PNI Trucker 9000 PL LED: distinctive CB antenna for cars and trucks
The PNI Trucker 9000 PL LED is a substantial vehicle CB antenna combining traditional stainless-steel construction with a distinctive transparent coil housing and LED design.
With a length of 140 cm, the antenna offers a conventional long-whip configuration for the 27 MHz CB band. When properly installed and calibrated, it provides an effective external antenna solution for the compact Luiton LT-198.
The Trucker 9000 is particularly attractive to CB enthusiasts and drivers looking for a recognizable antenna design rather than a miniature, low-profile aerial.
- Model: PNI Trucker 9000 PL LED (PNI-LED9000).
- Antenna length: 140 cm.
- Operating frequency: 26–28 MHz.
- Maximum antenna power rating: 1000W.
- Impedance: 50 Ohm.
- Minimum SWR: below 1.2 near the centre of the CB band under suitable tuned conditions.
- Polarization: vertical.
- Whip material: stainless steel.
- Coil housing: transparent, with LED design.
- Mounting connection: PL threaded type.
Note: The 1000W value is the manufacturer’s maximum applied power rating for the antenna, not the transmission power of the LT-198 radio, which remains 4W.
145 mm magnetic base: strong mounting without drilling
The included PNI 145/PL magnetic base makes it possible to mount the Trucker 9000 antenna on a suitable steel vehicle roof without drilling permanent holes in the bodywork.
The mounting system features a substantial magnetic base, protective rubber underside and 4 m coaxial cable with a PL259 connector for the radio.
- Magnetic base model: PNI 145/PL.
- Base diameter: 145 mm.
- Coaxial cable: 4 m RG58.
- Radio-side connector: PL259.
- Antenna connection: threaded PL mounting system.
- Protective underside: rubber layer.
- Mounting: removable, on suitable ferromagnetic vehicle surfaces.
The PL259 cable plug connects to the compatible SO-239 antenna socket on the Luiton LT-198.
Why choose the LT-198 with Trucker 9000?
This combination brings together two complementary advantages:
- Inside the vehicle: a small, fully functional 4W AM/FM CB radio with convenient controls and very little installation space required.
- Outside the vehicle: a traditional 140 cm stainless-steel CB antenna with a recognizable LED-equipped coil housing and substantial magnetic mounting base.
The result is an attractive CB setup for road communication, commercial vehicle use, convoy travel, recreational driving and everyday communication between compatible CB stations.
CB radio communication takes place directly over radio frequencies and does not depend on mobile Internet, Wi-Fi, SIM cards or subscriptions.
Vehicle installation and antenna calibration
Position the magnetic base on a clean, flat and suitable steel area of the vehicle, preferably near the centre of the roof when practical. Route the 4 m coaxial cable safely into the cabin and connect the PL259 plug to the radio.
Install the LT-198 using the supplied radio mounting bracket and connect it to a compatible 12/24V vehicle electrical supply.
Important: Before transmitting, check the antenna SWR using an appropriate meter. Depending on the installation, adjustment of the antenna whip may be required to obtain acceptable SWR values.
Always check the magnetic mount’s stability, antenna clearance, cable routing and vehicle height before driving. The antenna’s 140 cm length must be considered when entering garages, tunnels or other areas with limited overhead clearance.
Package contents
- 1 × Luiton LT-198 compact 4W AM/FM CB radio, updated 12/24V version.
- 1 × Luiton handheld microphone with channel controls.
- 1 × radio power cable.
- 1 × radio mounting bracket and screws.
- 1 × LT-198 user manual.
- 1 × PNI Trucker 9000 PL LED CB antenna, 140 cm.
- 1 × PNI 145/PL magnetic base, diameter 145 mm.
- 1 × 4 m RG58 coaxial cable with PL259 connector, supplied with the base.
CB SWR meter is not included. Minor manufacturer-supplied accessories may vary by product revision.
Frequently Asked Questions
Is this a complete CB radio kit for a car or truck?
Yes. The kit includes the LT-198 radio, microphone, mounting hardware, Trucker 9000 antenna, magnetic base and coaxial cable. Antenna installation and SWR calibration are required before transmission.
Does the Luiton LT-198 work with 12V and 24V vehicles?
Yes. The updated LT-198 version supports 12/24V vehicle electrical systems with a compatible power connection.
What is special about the PNI Trucker 9000 antenna?
The Trucker 9000 combines a traditional 140 cm stainless-steel CB whip with a distinctive transparent LED-equipped coil housing, a PL mounting system and a maximum applied antenna power rating of 1000W.
Does the 1000W antenna make the radio more powerful?
No. The Luiton LT-198 transmits at up to 4W. The antenna’s 1000W specification describes its maximum applied power capability, not the radio output or a guaranteed improvement in communication distance.
Can I install the antenna without drilling the car roof?
Yes. The supplied 145 mm magnetic base allows removable installation on a suitable steel surface without permanent holes.
Does the kit require Internet or a mobile phone network?
No. CB radios communicate directly via the 27 MHz radio band. No Internet connection, SIM card or subscription is required.
Does the antenna need tuning before use?
Yes. The SWR should be measured after installation, and the antenna adjusted if necessary before transmission. An SWR meter is required and is not included.
Regulatory note: Select the CB channel configuration permitted in your country and comply with applicable national regulations.
Regulatory note: Use only the CB channel configuration and operating settings permitted in the country where the equipment is used.
Operating note: Select the correct country/channel configuration and follow the applicable national CB radio regulations.
Package Contents: radio w/power cord, mounting bracket w/screws, microphone, user manual (EN, IT), antenna with cable, and connector.
Owner’s manual (installation and use instructions) for CB Radio Luiton LT-298:
https://radio.promarket.info/Luiton_LT-198_USER_Manual_wm.pdf
https://radio.promarket.info/User_Manual_Luiton_LT198_IT.pdf
You can find a detailed overview of this product in our blog.
Interested in learning more about 27 MHz CB radios? These articles will be helpful:
Frequently Asked Questions about CB (Citizens Band) Civil Radio (F.A.Q.)
Table (grid) of frequencies for radio stations of CB (civilian) range 27 MHz
Tips and Tricks: CB Radio 27 MHz – issue 1 – Installation in the Car.Basic information: https://radio.promarket-eu.com/index.html
Certain packaging elements, colors and minor details are subject to change by the manufacturer without notice.
Find more:
Luiton LT 198 CB Radio Unpacking YouTube Video
This post is also available in: Italiano (Italian)
